Universele richtlijnen tool

Naast de handleiding die je bij het stencil krijgt en onderaan deze pagina nogmaals kunt lezen, vind je hier nog een video met wat extra informatie over het gebruik. Er is Nederlandse ondertiteling beschikbaar, bekijk hiervoor de video via Youtube. 

In addition to the manual that you get with the stencil, which you can read again at the bottom of this page, you will find a video here with some extra information about its use.

For English: Read the subtitle by watching the video on You Tube. Thank you!

BUY HERE

NEDERLANDS
Handleiding: Deel 1
Stap 1: Zorg voor een (wit) pastel- of aquarelpotlood met een scherpe punt.
Stap 2: Leg het stencil over de middenmarking heen. Heeft jouw steen dit niet, meet deze dan eerst uit en markeer dit punt.
Stap 3: Zorg dat er bij het plaatsen van het stencil dat er tussen de uiteinden van deflappen evenveel ruimte zit.
Stap 4: Zet de markeringen, verwijder het stencil en verbind de markeringen eventueel met elkaar.

Waxinelichthouder – Deel 2
Wanneer je richtlijnen wilt uitzetten op een waxinelichthouder, kun je eventueel deel 2 ook aanschaffen. Dit is een houder die je in de ruimte van het waxinelicht kunt doen waar het stencil over kan. Dan weet je zeker dat je stencil gecentreerd is. Hiervoor moet de ruimte voor het waxinelichtje wel 4,2 cm zijn. 

Voor meer tips: Bekijk de video op www.JoyColorArt.com/tool

ENGLISH
Instructions: Part 1

Step 1: Get a white charcoal/pastel pencil and make sure you have a sharp tip.
Step 2: Lay down the flexible stencil over the center mark of your casted piece. If your stone does not have one, find the middle point and mark it.
Step 3: Make sure the spaces between the flaps of the flexible stencil are equal at every end.

Step 4: Mark the center using the white charcoal/pastel pencil and eventually any other areas you will work on. Remove the flexible stencil carefully and connect the marked areas with a compass if desired.

When you want to set out guidelines on a tea light holder, you can’t miss the second complementary part of the flexible stencil.
This is a holder that you can place in the open area meant for the candle. Using the flexible stencil over it, you know for sure that the markings will be properly centered. For this, the width of the tea light must be 4,2 cm.

For more tips watch the video at www.joycolorart.com/tool

SPANISH
Modo de empleo:  Herramienta Nr. 1.

Paso 1: Usar un lápiz tiza pastel color blanco y asegurarse de que tenga una punta afilada.
Paso 2: Colocar el estencil flexible sobre la marca central de la pieza. (Si la pieza no tiene una, encuentre primero el punto central y márquelo).
Paso 3: Asegurarse de que los espacios entre las solapas sean iguales en cada punta.

Paso 4: Marcar el centro con el lápiz tiza pastel blanco y cualquier otra área. Remover el estencil con cuidado y conectar las áreas marcadas con un compás si así lo desea.

Si quiere colocar líneas guía sobre un porta velas, usted puede obtener ésta segunda herramienta que le ayudará a alcanzar su objetivo de de manera fácil y rápida!. Así no tendrá más problemas para encontrar el centro de su pieza de trabajo.
Ésta herramienta se coloca en la abertura de el candelabro de yeso y calzando el estencil flexible por encima, sabrá con seguridad que éste está bien centrado. Para que ésto sea posible, el ancho para la velita debe ser de 4,2 cm.
Para más tips o referencias mire el video en el enlace www.joycolorart.com/tool